Why is the Cable Fault LED Red?
Posted by London Rhodes on Sep 26, 2022 9:48:23 AM
Topics: Troubleshooting, HS35iQ Encoder
Other Categories
Optical Rotary Encoders
Magnetic Rotary Encoders
Hollow-Shaft Encoders
Hub-Shaft Encoders
Shaft Encoders
Miniature Encoders
Hazardous Area Encoders
Non Contact Encoders
Bearingless Encoders
Ethernet Protocol Encoders
Service & Support Overview
Product Quicklinks
Competitor Parts List
Discontinued Encoder Guide
Literature Library
RMA Request
Technical Support
Product Manuals & Installation Guides
Knowledge Center
Technology
How to Choose Feedback
Application Examples
Case Studies
Encoder Issues and Troubleshooting
White Paper Downloads
Literature Library
Power Point Downloads
Videos
Featured Links
Motor Encoders
Quadrature Encoders
Optical Encoders
Magnetic Encoders
How to Specify a Resolver
Draw Wire Encoders
Hall Effect Encoders
Encoder Accuracy vs Resolution
Posted by London Rhodes on Sep 26, 2022 9:48:23 AM
If the cable fault LED continues to stay red after some toubleshooting, check the connection of every encoder signal connection. Make sure all signal outputs are connected to a load. If you are
using single ended mode, also ensure the Output Type is set correctly on the Fault Monitoring tab.
Topics: Troubleshooting, HS35iQ Encoder
© Copyright Dynapar 2025 All Rights Reserved